To replace the component, reverse the removal procedure.
Removing and replacing the LFF partition
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• Flat-headed screwdriver
• T-10 Torx screwdriver
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove LFF partition.
a. Use the flat-headed screwdriver and carefully pry the two box 1 fillers.
88 Removal and replacement procedures
To Next Page
Loading...
