8. If removed, connect the nonredundant power supply cable to system board.
To replace the component, reverse the removal procedure.
After the installation, the battery may take two hours to charge. The controller features that require
backup power are not re-enabled until the battery supports the backup power.
Removing and replacing the Smart Storage Battery holder
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Remove the air baffle.
6. Remove the Smart Storage Battery.
7. Remove the Smart Storage Battery holder.
60 Removal and replacement procedures
To Next Page
Loading...
