To replace the component, reverse the removal procedure.
Removing and replacing a Smart Array type-a modular
controller
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. If installed, remove the secondary riser cage.
7. Disconnect all cables from the storage controller.
8. Remove the storage controller.
Removal and replacement procedures 61
To Next Page
Loading...
