HP HPE ProLiant DL180 Gen10 - Removing and Replacing the Serial Port

4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Remove the LFF NVMe drive cage.
7. Remove all drives in the cage.
8. Remove the LFF NVMe drive backplane.
To replace the component, reverse the removal procedure.
Removing and replacing the serial port
Prerequisites
Nut screwdriver
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Remove the serial port.
Removal and replacement procedures 79