To replace the component, reverse the removal procedure.
Removing and replacing the LFF optical drive
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Remove the LFF optical drive cage.
7. Remove the optical drive.
Removal and replacement procedures 67
To Next Page
Loading...
