HP HPE ProLiant DL180 Gen10 - Removing and Replacing the Media Module

To replace the component, reverse the removal procedure.
Removing and replacing the Media Module
Prerequisites
T-15 Torx screwdriver
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Remove the primary riser cage.
6. Remove the Media Module:
a. Remove two T-15 screws.
b. Push the latch.
c. Remove the Media Module.
Removal and replacement procedures 65