5. Pull the drive straight forward approximately 3/4” to release the drive from the tab on the
chassis, then lift up and out to remove the drive from the chassis.
Replacing a Removable Media Drive
To replace the removable DVD drive, perform the following steps:
1. If a removable media drive has not previously been installed in the server, the drive slot will
be covered with a DVD drive filler. Remove the DVD drive filler.
2. Align the replacement drive over the tab on the chassis and lower the drive onto the tab. Slide
the drive toward the rear approximately 3/4” until it stops sliding and the retaining clips on
both sides of the drive snap into place.
3. Connect the IDE cable on the back of the drive.
4. Replace the cover.
5. Reconnect the power and external cables and turn on the system.
6. Verify that the replacement drive is operational.
• Run info io at the EFI shell to verify that the replacement drive has been properly
installed.
Removing and Replacing the Optional Management Processor Card
The optional management processor is an independent support system for the server. It provides
a way to connect to a server and perform administration or monitoring tasks for the server hardware.
Removing the Optional Management Processor Card
1. Turn off the system, disconnect all power and external cables and remove the system cover(s).
2. Record the network settings from your management processor card before beginning this task.
3. Unscrew the two mounting screws that connect the management processor card to the internal
chassis post and the two external mounting screws that are located on both sides of the 25-pin
serial connector.
4. Disconnect the management processor card connector.
5. Remove the management processor card from the system by grasping it by its edges.
6. Replace the management processor card blank, if available, on the chassis. This blank is used
to fill the holes left by the 10/100 Management LAN, 15-pin VGA, and 25-pin serial
connectors.
7. Push the management processor card blank against the inside of the chassis and screw in the
blank’s mounting screw on the external connector side of the system’s chassis.
8. Replace the cover(s) and reconnect the power and external cables.
Replacing the Optional Management Processor Card
1. Turn off the system, disconnect all power and external cables, and remove the system cover(s).
2. If you are replacing a card, remove the MP card.
3. Align the MP card over the two mounting posts on the system board and align the three
connectors of the MP card with the cutouts on the rear panel.
4. Carefully push the 10/100 Management LAN, 15-pin VGA, and 25-pin serial connectors
through their openings on the rear panel.
CAUTION: Special care should be used when mating the connectors of the MP card with
the sheet metal of the rear panel. It is possible to damage the EMI gasket of the RJ-45 LAN
connector of the card.
Removing and Replacing the Optional Management Processor Card 63
To Next Page
Loading...
Need help?
General