2 Installing and Configuring
This chapter provides information required in installing additional components and configuring
the HP Integrity rx1620 Server.
Service Tools Required
Service of this product may require one or more of the following tools:
• IPF CPU Install Tool Kit (P/N 5069-5441), consisting of:
Disposable ESD Kit◦
◦ Label-less CPU install tool (P/N 09901-04007)
• 1/4 inch Flat Blade Screwdriver
• ACX-10 Torx Screwdriver
• ACX-15 Torx Screwdriver
• ACX-25 Torx Screwdriver
Installing Internal Hard Disk Drives
This section provides information about installing internal hard disk drives.
CAUTION: A hot-plug device may require interaction with the operating system before the device
can be safely installed into the server. Verify that the operating system supports installing disk drives
while the operating system is running. If the operating system does not support this feature, shut
down the operating system before attempting this procedure. Failure to observe this caution will
result in system failure.
Figure 1 Front View of the HP Integrity rx1620 Server
One additional hard disk drive may be added to your HP Server in slot 1. Always use low profile
disk drives (1.0” height) in your HP Integrity rx1620.
To install an additional hard disk drive, perform the following steps:
Service Tools Required 7
To Next Page
Loading...
Need help?
General