Figure 62 Location of Management Processor Battery
3. Lift up on the battery and push on the back of it with a flat-head screwdriver to remove the
battery from its holder.
CAUTION: Only lift the battery high enough to clear the holder. Excessive stress on the
battery holder retaining clip may damage the clip.
Replacing the Optional Management Processor Card Battery
1. Lift up on the battery holder retaining clip with a flat-head screwdriver and slide the battery
into the holder. The positive (+) terminal of the battery faces up.
CAUTION: Only lift the battery high enough to clear the holder. Excessive stress on the
battery holder retaining clip may damage the clip.
2. Perform all of the steps described in the procedure for Replacing the optional management
processor card.
Replacing the Base Unit
Use this checklist to verify all parts from the original system have been moved to the base unit.
NOTE: Be sure to copy PRODUCT NUMBER, SERIAL NUMBER and UUID values onto the blank
labels and apply them to the base unit.
66 Removing and Replacing Components
To Next Page
Loading...
Need help?
General