HP Integrity rx1620 User Manual

Chapter 5
Troubleshooting
Identifying and Diagnosing Hardware Problems
95
a. Refer to “Removing and Replacing Components” in the hp Integrity rx1620 Maintenance Guide for
detailed instructions on the maintenance action.
Table 5-18 Processor Faults
System
LED
LED 1 LED 2 LED 3 LED 4 Problem Solution
Flashing
Red
Red Red Green Off Processor 0
temperature
exceeds limit
Make sure nothing is blocking the
system’s airflow and locate your
system in an air-conditioned
room. In a single CPU
configuration, verify that the
airflow blocker is installed.
Flashing
Red
Red Red Off Green Processor 1
temperature
exceeds limit
Flashing
Red
Red Red Green Green No processor
detected.
Verify that the processor or
processors are correctly installed.
See “Installing and Configuring”
in the hp Integrity rx1620
Maintenance Guide for
installation procedures.
Table 5-19 BMC Faults
System
LED
LED 1 LED 2 LED 3 LED 4 Problem Solution
Flashing
Red
Red Green Red Off BMC
firmware is
damaged
Turn off and unplug the system.
Wait 20 seconds, then plug in and
restart the system. If the error
repeats, replace the base unit.
Flashing
Red
Red Green Red Green System
board FRU
inventory
device
inaccessible
Replace the base unit.
Table 5-20 Temperature Faults
System
LED
LED 1 LED 2 LED 3 LED 4 Problem Solution
Flashing
Red
Red Green Green Red External air
temperature
too high
Make sure nothing is blocking
the system’s airflow and locate
your system in an
air-conditioned room.

HP Integrity rx1620 Specifications

General

Brand	HP
Model	Integrity rx1620
Category	Server
Language	English