EN
Troubleshooting the Printing System
7-39
68 NVRAM FULL
CHECK SETTINGS
An error occurred in the
printer’s nonvolatile
memory (NVRAM) and
one or more printer
settings has been reset to
its factory default.
1. Print a Configuration
Page and check the
printer settings to
determine which values
have changed.
2. Hold down
[Cancel
Job]
while turning the
printer on. This will clean
up the NVRAM by
removing old areas that
are not being used.
69.x
PRINTER ERROR
A temporary printing error
occurred.
X Description
0 The duplex mechanism
has failed.
1. Turn the printer off, and
then turn the printer on.
2. Reseat the Duplexer.
Table 7-6. Numerical Printer Messages (continued)
Control Panel
Message
Event Log
Message
Explanation Recommended
Action
To Next Page
Loading...