272 • STN Reference HP NonStop SSH Reference Manual
PROCESS_CREATE_ error 15: no pcbs available.
STN31 unlicensed privileged program
PROCESS_CREATE_ error 17.
STN32 library conflict
PROCESS_CREATE_ error 18.
STN33 PROG and LIB files the same
PROCESS_CREATE_ error 19.
STN34 process_create_ error <status> substatus <substatus>
PROCESS_CREATE_ error <status> with detail <substatus>.
STN35 **WARNING** Terminal will be disconnected if it stays idle...
Terminal has been idle and is within IDLE_WARNING minutes of BANNER_TIMEOUT or INPUT_TIMEOUT.
STN36 Terminal was idle too long! Disconnecting...
Terminal has been idle for BANNER_TIMEOUT or INPUT_TIMEOUT minutes.
STN37 BLAST <text>
System operator used STNCOM command BLAST to send <text> to all terminals.
STN38 No application program active on this terminal for nnn seconds. Session terminated.
At the beginning of a session, OPENER_WAIT seconds have elapsed and no application has opened the window.
STN39 Session terminated - application request (control 12) <time>
The application has disconnected the session via control 12. This is normal termination for some applications.
After session termination, 6530 terminals will always be left in conversational (ITI) mode, and the terminal display is
erased.
STN39 Session terminated - application closed terminal <time>
The application has closed the window and AUTODEL_WAIT seconds have elapsed. This is normal termination for
some applications.
After session termination, 6530 terminals will always be left in conversational (ITI) mode, and the terminal display is
erased.
To Next Page
Loading...
Need help?
General