Key installation steps
Set up the rack.Step 1
Install mezzanine cards on the server blades.Step 3
Install BladeSystem c-Class enclosure and its servers, interconnect devices, and other
components. Install operating system updates and patches, and, if necessary, update firmware
on the HP mezzanines and interconnect devices.
Step 4 and
nl
Step 5
For each server that will boot locally (not use the storage enclosure as a boot device), install
the operating system.
Step 6
Install P2000 G3 SAS MSA Array controller and drive enclosures. If necessary, update the
firmware.
Step 7
Configure zoning on the switch.Step 8
Configure the P2000 G3 SAS MSA Array controllers and storage.Step 10
40 Installation best practices and procedures
To Next Page
Loading...
