To Next Page

To Previous Page

Quality of Service (QoS): Managing Bandwidth More Effectively

Using QoS Classifiers To Configure QoS for Outbound Traffic

2. Configure the priorities for the DSCPs you want to use.

DSCP Policies

Configured in this step.

Figure 6-12. Assigning 802.1p Priorities to the Selected DSCPs

3. Assign the DSCP policies to the selected device IP addresses and display

the result.

Figure 6-13. The Completed Device-Priority/Codepoint Configuration

The switch will now apply the DSCP policies in figure 6-12 to IPv4 packets

received on the switch with the specified IP addresses (source or destination).

This means the switch will:

■ Overwrite the original DSCPs in the selected packets with the new DSCPs

specified in the above policies.

■ Assign the 802.1p priorities in the above policies to the appropriate

packets.

6-33

Other manuals for HP ProCurve 2610

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2610 and is the answer not in the manual?

General