ProCurve Stack Management
Configuring Stack Management
Figure 8-7. The Default Commander Configuration in the Stack Configuration
Screen
6. Enter a unique stack name (up to 15 characters; no spaces) and press the
downarrow key.
7. Ensure that the Commander has the desired Auto Grab setting, then press
the downarrow key:
• No (the default) prevents automatic joining of Candidates that
have their Auto Join set to Yes.
• Yes enables the Commander to automatically take a Candidate
into the stack as a Member if the Candidate has Auto Join set to
Yes (the default Candidate setting) and does not have a previously
configured password.
8. Accept or change the transmission interval (default: 60 seconds), then
press
[Enter] to return the cursor to the Actions line.
9. Press
[S] (for Save) to save your configuration changes and return to the
Stacking menu.
Your Commander switch should now be ready to automatically or manually
acquire Member switches from the list of discovered Candidates, depending
on your configuration choices.
Using the Menu To Manage a Candidate Switch
Using the menu interface, you can perform these actions on a Candidate
switch:
■ Add (“push”) the Candidate into an existing stack
■ Modify the Candidate’s stacking configuration (Auto Join and Transmission
Interval
)
8-15
To Next Page
Loading...
Need help?
General
