Static Virtual LANs (VLANs)
Port-Based Virtual LANs (Static VLANs)
Showing Port Details for VLANs
The show vlan ports detail option allows you to display VLAN memberships on
a per-port basis when a range of ports is specified in the command. In addition,
user-specified port names will be displayed (if assigned), along with tagged or
untagged membership modes.
Syntax: show vlan ports < port-list > [detail]
Displays VLAN information for an individual port or a group of
ports, either cumulatively or on a detailed per-port basis.
port-list: Specify a single port number, a range of ports (for example,
a1-a16), or all.
detail: Displays detailed VLAN membership information on a per-
port basis.
Descriptions of items displayed by the command are provided
below.
Port name: The user-specified port name, if one has been assigned.
VLAN ID: The VLAN identification number, or VID.
Name: The default or specified name assigned to the VLAN. For
a static VLAN, the default name consists of VLAN-x where “x”
matches the VID assigned to that VLAN. For a dynamic VLAN,
the name consists of GVRP_x where “x” matches the applicable
VID.
Status:
Port-Based: Port-Based, static VLAN
Protocol: Protocol-Based, static VLAN
Dynamic: Port-Based, temporary VLAN learned through
GVRP.
Voice: Indicates whether a (port-based) VLAN is configured as a
voice VLAN.
Jumbo: Indicates whether a VLAN is configured for Jumbo
packets. For more on jumbos, refer to the chapter titled “Port
Traffic Controls” in the Management and Configuration Guide for
your switch.
Mode: Indicates whether a VLAN is tagged or untagged.
2-24
To Next Page
Loading...
Need help?
General