To Next Page

To Previous Page

Static Virtual LANs (VLANs)

Port-Based Virtual LANs (Static VLANs)

VLAN Commands Used in this Section

show vlans below

show vlan <vlan-id> page 2-23

max-vlans page 2-26

primary-vlan <vlan-id> page 2-26

[no] vlan <vlan-id> page 2-26

name <vlan-name> page 2-28

[no] tagged <port-list> page 2-28

[no] untagged <port-list> page 2-28

[no] forbid page 2-28

auto <port-list> page 2-28 (Available if GVRP enabled.)

static-vlan <vlan-id> page 2-27 (Available if GVRP enabled.)

Displaying the Switch’s VLAN Configuration

The next command lists the VLANs currently running in the switch, with VID,

VLAN name, and VLAN status. Dynamic VLANs appear only if the switch is

running with GVRP enabled and one or more ports has dynamically joined an

advertised VLAN. (In the default configuration, GVRP is disabled. (See chapter

3, “GVRP”.)

Syntax: show vlan

When GVRP is disabled

(the default), Dynamic

VLANs do not exist on

the switch and do not

appear in this listing.

(See chapter 3,

“GVRP”.)

Figure 2-17. Example of “Show VLAN” Listing (GVRP Enabled)

2-22

Other manuals for HP ProCurve 2610

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2610 and is the answer not in the manual?

General