To Next Page

To Previous Page

GVRP

Introduction

3. Use the arrow keys to select the port you want, and the Space bar to select

Unknown VLAN option for any ports you want to change.

4. When you finish making configuration changes, press

[Enter], then [S] (for

ave) to save your changes to the Startup-Config file.

CLI: Viewing and Configuring GVRP

GVRP Commands Used in This Section

show gvrp below

gvrp page 3-14

unknown-vlans page 3-14

Displaying the Switch’s Current GVRP Configuration. This command

shows whether GVRP is disabled, along with the current settings for the

maximum number of VLANs and the current Primary VLAN. (For more on the

last two parameters, see “Port-Based Virtual LANs (Static VLANs)” on page

2-4.)

Syntax: show gvrp

Shows the current settings.

Figure 3-6. Example of “Show GVRP” Listing with GVRP Disabled

3-13

Other manuals for HP ProCurve 2610

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2610 and is the answer not in the manual?

General