To Next Page

To Previous Page

Spanning-Tree Operation

802.1s Multiple Spanning Tree Protocol (MSTP)

Displaying the MSTP Configuration

Displaying the Global MSTP Configuration. This command displays the

switch’s basic and MST region spanning-tree configuration, including basic

port connectivity settings.

Syntax: show spanning-tree config

The upper part of this output shows the switch’s global

spanning-tree configuration that applies to the MST region.

The port listing shows the spanning-tree port parameter

settings for the spanning-tree region operation (configured by

the spanning-tree < port-list > command). For information on

these parameters, refer to “Configuring Basic Port

Connectivity Parameters” on page 5-63.

Syntax: show spanning-tree < port-list > config

This command shows the same data as the above command,

but lists the spanning-tree port parameter settings for only the

specified port(s) and/or trunk(s). You can list data for a series

of ports and port trunks by specifying the first and last port

or trunk of any consecutive series of ports and trunks. For

example, to display data for port A20-A24 and trk1, use this

command: show spanning-tree a20-trk1 config

Global Hello Time

Per-Port Hello Time

(Overrides Global Hello-

Time on individual ports.)

Per-Port Priority

Global Priority

Figure 5-30. Example of Displaying the Switch’s Global Spanning-Tree Configuration

5-77

Other manuals for HP ProCurve 2610

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2610 and is the answer not in the manual?

General