HP ProLiant DL380 G3 - Preparation Procedures; Extending the Server from the Rack

18 HP ProLiant DL380 Generation 3 Server Maintenance and Service Guide
Preparation Procedures
To access some components and perform certain service procedures, you must
perform one or more of the following procedures:
•
•
•
Extend the server from the rack ("Extending the Server from the Rack" on
page 18).
If you are performing service procedures in a Compaq branded rack, Telco
rack, or third-party rack cabinet, you can use the locking feature of the rack
rails to support the server and gain access to internal components.
For more information about Telco rack solutions, refer to
www.racksolutions.com/hp
Power down the server ("Powering Down the Server" on page 20).
If you must remove a server from a rack or a non-hot-plug component from a
server, power down the server.
Remove the server from the rack ("Removing the Server from the Rack" on
page 21).
If the rack environment, cabling configuration, or the server location in the
rack creates awkward conditions, remove the server from the rack.
Extending the Server from the Rack
1. Loosen the thumbscrews that secure the server faceplate to the front of the
rack.
2. Extend the server on the rack rails until the server rail-release latches engage.
HP CONFIDENTIAL
File Name: 291916-3.doc Last Saved On: 5/19/03 10:29 AM