Removal and Replacement Procedures 25
Universal Hot-Plug Tape Drive
To remove the component:
CAUTION: To prevent improper cooling and thermal damage,
do not operate the server unless all bays are populated with either a
component or a blank.
To replace the Universal Hot-Plug tape drive, slide the drive into the bay until it
locks into place.
Tape Drive Blank
To remove the component:
1. Remove the hot-plug SCSI hard drive, if one is installed, below the tape
drive blank ("Hot-Plug SCSI Hard Drive" on page 21).
2. Remove the hard drive blank, if one is installed, below the tape drive blank
("Hard Drive Blank" on page 23).
HP CONFIDENTIAL
File Name: 291916-3.doc Last Saved On: 5/19/03 10:29 AM
To Next Page
Loading...
