Removal and Replacement Procedures 41
6. Remove the Universal Media Bay adapter board.
To replace the component, reverse the removal procedure.
CD Ejector Assembly
To remove the component:
1. Power down the server ("Powering Down the Server" on page 20).
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 18, "Removing the Server from the Rack" on page 21).
3. Remove the access panel ("Removing the Access Panel" on page 21).
4. Remove the CD-ROM drive, if installed ("CD-ROM Drive" on page 38).
5. Remove the CD-ROM drive blank, if installed ("CD-ROM Drive Blank" on
page 24).
6. Remove the diskette drive ("Diskette Drive" on page 39).
7. Remove the Universal Media Bay adapter board ("Universal Media Bay
Adapter Board" on page 40).
HP CONFIDENTIAL
File Name: 291916-3.doc Last Saved On: 5/19/03 10:29 AM
To Next Page
Loading...
