HP ProLiant DL380 G3 - SCSI Backplane

44 HP ProLiant DL380 Generation 3 Server Maintenance and Service Guide
4. Remove the front fan bracket ("Front Fan Bracket" on page 43).
IMPORTANT: For this procedure, you do not need to remove the hot-
plug fans from the front fan bracket. When reinstalling the front fan
bracket, press the top of each fan to be sure it seats securely.
5. Remove the SCSI terminator.
To replace the component, reverse the removal procedure.
SCSI Backplane
To remove the component:
1. Power down the server ("Powering Down the Server" on page 20).
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 18, "Removing the Server from the Rack" on page 21).
3. Remove the access panel ("Removing the Access Panel" on page 21).
4. Remove all hot-plug SCSI hard drives ("Hot-Plug SCSI Hard Drive" on page
21).
5. Remove the tape drive, if installed ("Universal Hot-Plug Tape Drive" on
page 25).
6. Remove the front fan bracket ("Front Fan Bracket" on page 43).
HP CONFIDENTIAL
File Name: 291916-3.doc Last Saved On: 5/19/03 10:29 AM