EasyManuals Logo

HP ProLiant ML150 User Manual

HP ProLiant ML150
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #119 background imageLoading...
Page #119 background image
C
Power Cord Set Requirements
The power cord set meets the requirements for use in the country where you purchased your
equipment. The voltage selection switch allows you to select the appropriate line voltage for
the HP server.
Power cord sets for use in other countries must meet the requirements of the country where
you use the server. For more information on power cord set requirements, contact your
Authorized HP Dealer
General Requirements
The requirements listed below are applicable to all countries:
The length of the power cord must be at least 1.8 m (6.0 ft) and a maximum of 3.7 m
(12 ft).
The power cord set must be approved by an acceptable accredited agency responsible for
evaluation in the country where the power cord will be used.
The power cord set must have a minimum current capacity and nominal voltage rating of
10 A/125 volts AC, or 10A/250 volts AC, as required by the power system of each
country.
The appliance coupler must meet the mechanical configuration of an EN60320/IEC60320
Standard Sheet C13 Connector, for mating with the appliance outlet on the computer.
HP ProLiant ML150 Server Operations and Maintenance Guide C-1
HP CONFIDENTIAL Codename: Stone Soup Part Number: 343329-001 Last Saved On: 8/14/03 10:42 AM

Table of Contents

Other manuals for HP ProLiant ML150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProLiant ML150 and is the answer not in the manual?

HP ProLiant ML150 Specifications

General IconGeneral
Tcase72.8 °C
Bus typeQPI
SteppingR2
FSB ParityNo
Scalability2S
Processor cache15 MB
Processor cores6
Processor modelE5-2603V3
System bus rate6.4 GT/s
Processor seriesIntel Xeon E5-2600 v3
Processor socketLGA 2011-v3
Processor codenameHaswell
Motherboard chipsetIntel C610
Number of QPI links2
Processor frequency1.6 GHz
Processor cache typeSmart Cache
Processor lithography22 nm
Processor manufacturerIntel
Processor package size52.5 x 45 mm
Processor front side bus- MHz
Processor operating modes64-bit
ECC supported by processorYes
PCI Express configurationsx4, x8, x16
Supported instruction setsAVX 2.0
Thermal Design Power (TDP)85 W
Number of processors installed1
Physical Address Extension (PAE)46 bit
Maximum number of PCI Express lanes40
Memory types supported by processorDDR4-SDRAM
Memory channels supported by processorQuad
Memory clock speeds supported by processor1600 MHz
Memory bandwidth supported by processor (max)51 GB/s
Maximum internal memory supported by processor768 GB
HDD size- \
RAID support-
HDD interfaceSerial ATA
Total storage capacity0 GB
Maximum storage capacity- TB
Number of HDDs installed0
Memory slots16x DIMM
Internal memory4 GB
Memory clock speed2133 MHz
Maximum internal memory256 GB
Memory layout (slots x size)1 x 4 GB
Graphics card familyNVIDIA
Intel® Virtualization Technology (Intel® VT)VT-d, VT-x
Ethernet interface typeGigabit Ethernet
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity4
Chassis typeRack (1U)
Power supply550 W
Processor ARK ID83349
Intel Secure Key Technology version1.00
Intel Identity Protection Technology version0.00
PCI Express slots version3.0
Weight and Dimensions IconWeight and Dimensions
Depth620 mm
Width200 mm
Height432.6 mm
Weight22230 g

Related product manuals