HP ProLiant ML150 User Manual

Troubleshooting
User Password
If you need to reset the User password and you know the Supervisor password, perform the
following steps:
1. Restart the HP server.
2. During the boot process, press the Delete key to start the system BIOS Setup Utility.
3. Enter the Supervisor password and once in the Setup Utility, go to the Security menu.
4. Move to the Change User Password menu selection and press the Enter key.
5. Enter the new User password and press the Enter key.
6. Reconfirm the new User password and press the Enter key. This sets a new User
password.
7. Exit the Setup Utility and save the changes to save the new password.
General Server Problems
“Operating System Not Found” Message Appears
1. Check for a non-bootable diskette in the flexible disk drive. If found, remove the diskette
form the drive.
2. Check for a tape in the tape drive. If found, remove the tape cartridge from the drive.
3. Power on the HP server. If the message still appears, reboot the HP server and when
prompted, enter the system BIOS Setup Utility and check that the device boot order is
correct.
4. If a disk array controller is being used and the NOS is installed on a hardware
array/container, verify that the array/container is in an optimal state by accessing and
checking the disk array controller’s setup utility during startup.
5. Boot to a DOS disk and check the partitions to ensure the primary partition is active.
If the problem persists, contact the HP Customer Support Center for further troubleshooting
assistance.
HP ProLiant ML150 Server Operations and Maintenance Guide 4-9
HP CONFIDENTIAL Codename: Stone Soup Part Number: 343329-001 Last Saved On: 8/14/03 10:25 AM

HP ProLiant ML150 Specifications

General

Tcase	72.8 °C
Bus type	QPI
Stepping	R2
FSB Parity	No
Scalability	2S
Processor cache	15 MB
Processor cores	6
Processor model	E5-2603V3
System bus rate	6.4 GT/s
Processor series	Intel Xeon E5-2600 v3
Processor socket	LGA 2011-v3
Processor codename	Haswell
Motherboard chipset	Intel C610
Number of QPI links	2
Processor frequency	1.6 GHz
Processor cache type	Smart Cache
Processor lithography	22 nm
Processor manufacturer	Intel
Processor package size	52.5 x 45 mm
Processor front side bus	- MHz
Processor operating modes	64-bit
ECC supported by processor	Yes
PCI Express configurations	x4, x8, x16
Supported instruction sets	AVX 2.0
Thermal Design Power (TDP)	85 W
Number of processors installed	1
Physical Address Extension (PAE)	46 bit
Maximum number of PCI Express lanes	40
Memory types supported by processor	DDR4-SDRAM
Memory channels supported by processor	Quad
Memory clock speeds supported by processor	1600 MHz
Memory bandwidth supported by processor (max)	51 GB/s
Maximum internal memory supported by processor	768 GB
HDD size	- \
RAID support	-
HDD interface	Serial ATA
Total storage capacity	0 GB
Maximum storage capacity	- TB
Number of HDDs installed	0
Memory slots	16x DIMM
Internal memory	4 GB
Memory clock speed	2133 MHz
Maximum internal memory	256 GB
Memory layout (slots x size)	1 x 4 GB
Graphics card family	NVIDIA
Intel® Virtualization Technology (Intel® VT)	VT-d, VT-x
Ethernet interface type	Gigabit Ethernet
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	4
Chassis type	Rack (1U)
Power supply	550 W
Processor ARK ID	83349
Intel Secure Key Technology version	1.00
Intel Identity Protection Technology version	0.00
PCI Express slots version	3.0

Weight and Dimensions

Depth	620 mm
Width	200 mm
Height	432.6 mm
Weight	22230 g