HP ProLiant ML150 User Manual

Troubleshooting
4. Boot the HP server with the BIOS update diskette in the flexible disk drive. The BIOS
Utility Update program will start and you will be prompted to update the system BIOS.
5. After the BIOS update is complete, remove the BIOS update diskette and then reboot the
HP server.
6. Press the Delete key to enter the BIOS Setup Utility and make the necessary changes
needed in the BIOS Setup Utility, press the F10 key to save the changes and exit the
utility.
7. Label, date, and save this flexible diskette for use as a BIOS Recovery diskette.
NOTE: If you do not have convenient access to the Internet, you can create a BIOS Update/Recovery
diskette from the HP Startup CD-ROM. Please note that the CD-ROM may not provide the most recent
BIOS. To create the BIOS Update/Recovery diskette, run HP Startup CD-ROM on any Windows PC
with an HTML browser and follow the menu instructions.
Clearing the BIOS Configuration
NOTE: It is recommended that the system’s setup and configuration settings be noted before clearing
the BIOS configuration as this will reset all settings back to the default.
You may need to clear the BIOS (CMOS) configuration if the configuration has become
corrupt or if incorrect settings made in the Setup Utility have caused error messages to be
unreadable.
To clear the configuration, refer to “Clearing the CMOS Configuration” in Chapter 3 for the
detailed information.
Password Problems
Supervisor Password
1. Power off the HP server.
2. Clear the CMOS configuration as described in the “Clearing the CMOS Configuration”
section of Chapter 3.
3. Power on the HP server. The system BIOS Setup Utility will allow access to it now
without having to enter any password.
4. A new Supervisor password can now be set from the system BIOS Setup Utility.
4-8 HP ProLiant ML150 Server Operations and Maintenance Guide
HP CONFIDENTIAL Codename: Stone Soup Part Number: 343329-001 Last Saved On: 8/14/03 10:25 AM

HP ProLiant ML150 Specifications

General

Tcase	72.8 °C
Bus type	QPI
Stepping	R2
FSB Parity	No
Scalability	2S
Processor cache	15 MB
Processor cores	6
Processor model	E5-2603V3
System bus rate	6.4 GT/s
Processor series	Intel Xeon E5-2600 v3
Processor socket	LGA 2011-v3
Processor codename	Haswell
Motherboard chipset	Intel C610
Number of QPI links	2
Processor frequency	1.6 GHz
Processor cache type	Smart Cache
Processor lithography	22 nm
Processor manufacturer	Intel
Processor package size	52.5 x 45 mm
Processor front side bus	- MHz
Processor operating modes	64-bit
ECC supported by processor	Yes
PCI Express configurations	x4, x8, x16
Supported instruction sets	AVX 2.0
Thermal Design Power (TDP)	85 W
Number of processors installed	1
Physical Address Extension (PAE)	46 bit
Maximum number of PCI Express lanes	40
Memory types supported by processor	DDR4-SDRAM
Memory channels supported by processor	Quad
Memory clock speeds supported by processor	1600 MHz
Memory bandwidth supported by processor (max)	51 GB/s
Maximum internal memory supported by processor	768 GB
HDD size	- \
RAID support	-
HDD interface	Serial ATA
Total storage capacity	0 GB
Maximum storage capacity	- TB
Number of HDDs installed	0
Memory slots	16x DIMM
Internal memory	4 GB
Memory clock speed	2133 MHz
Maximum internal memory	256 GB
Memory layout (slots x size)	1 x 4 GB
Graphics card family	NVIDIA
Intel® Virtualization Technology (Intel® VT)	VT-d, VT-x
Ethernet interface type	Gigabit Ethernet
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	4
Chassis type	Rack (1U)
Power supply	550 W
Processor ARK ID	83349
Intel Secure Key Technology version	1.00
Intel Identity Protection Technology version	0.00
PCI Express slots version	3.0

Weight and Dimensions

Depth	620 mm
Width	200 mm
Height	432.6 mm
Weight	22230 g