HP ProLiant ML150

Installing and Configuring
SCSI Configuration Utility
The HP server uses the SCSISelect Utility to verify or modify the embedded SCSI controller
settings for the devices connected to the two SCSI channel connectors on the system board. If
you need to verify or modify SCSI controller settings, or if you need to low-level format
SCSI disks or verify SCSI disk media, run the SCSISelect Utility.
NOTE: You typically would not need to use this utility unless you are an experienced administrator or
requested to do so by a support provider.
Starting SCSISelect
Follow these steps to start SCSISelect:
1. Turn on the monitor and the HP server.
During the startup process, pay careful attention to the messages that display on your
screen.
2. When the following message displays on your screen, press the Ctrl-A keys
simultaneously (this message displays for only a few seconds):
Press <Ctrl><A> for SCSISelect(TM) Utility!
3. From the menu that displays, use the arrow keys to move the cursor to the option you
want to select, then press the Enter key.
NOTE: If you have difficulty viewing the display, press the F5 key to toggle between color and
monochrome modes. (This feature may not work on some monitors.)
Exiting SCSISelect
Follow these steps to exit SCSISelect:
1. Press the Esc key until a message prompts you to exit (if you changed any settings, you
are prompted to save the changes before you exit).
2. At the prompt, select Yes to exit, then press any key to reboot the server. Any changes
made in SCSISelect will take effect the next time the server is booted.
HP ProLiant ML150 Server Operations and Maintenance Guide 2-41
HP CONFIDENTIAL Codename: Stone Soup Part Number: 343329-001 Last Saved On: 8/14/03 10:09 AM