Table 50 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WIf this was a path operation
retry after the problem has
been fixed.
If this was a pair operation,
retry after the paths have
been recovered. Two ways
to recover paths are:
(a) Execute ESTPATH from
the host console, or
(b) First delete the path(s)
from the SVP, then re-add
them.
The operation was rejected due to a
'FREEZE' state.
87126005
WThe port type could not be
changed because the port
group was set in the
specified package. Delete
the group setting, then
change the port type.
The port group already exists on the
specified port.
87136005
EPlease contact HP Technical
Support.
An internal error occurred.87146005
WThe specified number of
paths is not within the
acceptable path range of 0
to 4. Verify the number of
paths and retry the
operation.
Invalid number of paths.87156005
WThe specified logical
address must be either 00
or 01. Check the logical
address and retry the
operation.
Invalid Destination Link Address.87176005
WCheck all existing logical
path addresses, and specify
another link address or port.
The specified logical path already
exists.
87186005
WCheck the serial number,
SSID, link address and
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, please
contact HP Technical
Support.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
87196005
WA maximum of four RCUs
are permitted, and that
many already exist.
Too many RCUs. (Four RCUs are the
maximum.)
87206005
WCheck the path connections
between the MCU and the
RCU, then retry the
operation.
Path not completely established.87216005
WCheck the path connections
between the MCU and the
RCU, then retry the
operation.
Failure during path creation.87226005
Part code 6005 141
To Next Page
Loading...
