HP StorageWorks P9000

Table 50 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WCheck the serial number,
SSID and link address of the
RCU, and set the correct
value. Then retry the
operation. If the same error
occurs, please contact HP
Technical Support.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
87356005
WDelete all Remote Copy
volume pairs of the specified
RCU or SSID, and retry the
operation.
The specified RCU or SSID contains
some Remote Copy volume pairs.
87366005
EPlease contact HP Technical
Support.
An internal error occurred.87376005
WThe emulation type of the
MCU does not support
Continuous Access
Synchronous. If you want to
use Continuous Access
Synchronous, please contact
HP Technical Support.
Remote Copy is not supported under
the MCU Controller emulation type.
87386005
WThe MCU NVS status
specified by the host is not
active. Set the NVS to “on”
for the MCU, using any
attached host, then retry the
operation.
NVS status of MCU is not active.87396005
WThe RCU NVS status
specified by the host is not
active. Use any attached
host to set the NVS to “on”
for the MCU, then retry the
operation.
NVS status of RCU is not active.87406005
WCheck the path status
between the MCU and the
RCU.
The logical paths between the MCU
and RCU are not established.
87416005
WCheck the status of the
M-VOL tracks, and clear the
pinned tracks.
Pinned track(s) exists on the M-VOL.87426005
WCheck the status of the
R-VOL tracks, and clear the
pinned tracks.
Pinned track(s) exists on the R-VOL.87436005
Part code 6005 143