HP StorageWorks P9000

Table 50 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WThe M-VOL is not available
for the requested operation,
because of one or more of
the following reasons:
• The volume is blocked.
• The volume is under
maintenance.
• The volume is copying
data (correction copy or
drive copy).
• The volume is in the
correction access
condition.
Check the logical device
status of the specified
M-VOL. If the M-VOL is
either under maintenance or
copying data, retry the
operation after the process
is completed.
The specified M-VOL condition is not
valid for Remote Copy.
87446005
WSelect another volume.A volume cannot be used as an R-VOL
when:
• it is used by Compatible XRC.
• it is used by PPRC or Remote Copy.
• it is used by Concurrent Copy.
• it is in a reserved condition.
• it is used by Continuous Access
Journal or Continuous Access Journal
Z.
• it is used by Business Copy Z or
Compatible FlashCopy.
87456005
WSee the INSTALLATION
SECTION and
OPENPLATFORM SECTION
in the maintenance manual
to confirm whether the
device emulation type of the
M-VOL is supported by
Remote Copy.
The device emulation type of the M-VOL
is not supported.
87466005
WThe version of the microcode
on the 9900 storage system
does not support the
specified function or
operation. Please contact HP
Technical Support.
Current microcode version does not
support the specified operation.
87476005
WData migration cannot start
because the volume is
online. Vary the path offline,
and retry.
Specified M-VOL may be in use by
HOST.
87486005
144 Message (part code group 6nnn)