Table 52 Error codes (part code 6010) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
iFollow the instructions in the message.WARNING: Destination volume of
specified volume pair may contain some
inconsistency, because volume copy is
not completed yet. Full volume
initialization is required before re-using
it.
93006010
iFollow the instructions in the message.WARNING: Through this operation,
M-VOL status will be changed to SMPL
status forcibly, but R-VOL status will not
be changed. If you do this operation,
please change the R-VOL status to SMPL
later.
93016010
WConfirm whether the command device
for Business Continuity Manager is
defined.
There are no valid volumes.93036010
WSet the port to Initiator before registering
RCU.
There are no initiator ports.93056010
WThere is no Remote Copy license. Set the
license.
The Remote Copy function is not installed
in this controller. You cannot create
pairs.
93066010
WSince the same volume where multiple
paths are defined was selected, the
overlapped one was eliminated. Click
[OK] and continue.
You specified the same volumes more
than once. The duplicate occurrences
were excluded.
93076010
WSince there were overlapped paths in
the added paths, the overlapped paths
were eliminated. Click [OK] and
continue.
You set the same path more than once.
The duplicate paths are excluded.
93086010
WSince all the added paths overlapped,
the operation of adding paths cannot be
executed. Click [OK] and continue.
All paths which you set have already
been registered. This operation will
terminate because there is no path which
can be added.
93096010
WSince there were overlapped SSIDs in
the added SSIDs, the overlapped SSIDs
were eliminated. Click [OK], and
continue.
You set the same SSID more than once.
Duplicate SSIDs are excluded.
93106010
WSince all the added SSIDs are
overlapped, the operation of adding
SSIDs cannot be executed. Click [OK],
and continue.
All SSIDs which you set have already
been registered. This operation will
terminate because there is no SSID which
can be added.
93116010
WFollow the instructions in the message.Through this operation, M-VOL status will
be changed to Simplex mode even if the
M-VOL is online to the host.
93166010
iFollow the instructions in the message.The destination volume of the specified
volume pair may contain some
inconsistency because volume copy is
not completed yet. Full volume
initialization is required before re-using
it.
93176010
iTo delete the pair, even though you
cannot re-execute the R-VOL deletion,
click [OK]. If not, click [Cancel].
As a result of this operation, you will not
be able to re-start ERASE R-VOL
operation.
93186010
172 Message (part code group 6nnn)
To Next Page
Loading...
