164 Command Reference
Examples The following is an example of the ipsec association create command:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> ipsec edit
SN6000 FC Switch (admin-ipsec) #> ipsec association create h2h-sh-sa
A list of attributes with formatting will follow.
Enter a value or simply press the ENTER key to skip specifying a value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Required attributes are preceded by an asterisk.
Value (press ENTER to not specify value, 'q' to quit):
Description (string value, 0-127 bytes) :
Host-to-host:switch->host
*SourceAddress (hostname, IPv4, or IPv6 Address) :
fe80::2c0:ddff:fe03:d4c1
*DestinationAddress (hostname, IPv4, or IPv6 Address) :
fe80::250:daff:feb7:9d02
*Protocol (1=esp, 2=esp-old, 3=ah, 4=ah-old) : 1
*SPI (decimal value, 256-4294967295) : 333
Authentication (select an authentication algorithm)
1=hmac-md5 (16 byte key)
2=hmac-sha1 (20 byte key)
3=hmac-sha256 (32 byte key)
4=aes-xcbc-mac (16 byte key)
authentication algorithm choice : 2
*AuthenticationKey (quoted string or raw hex bytes): "12345678901234567890"
*Encryption (select an encryption algorithm)
1=des-cbc (8 byte key)
2=3des-cbc (24 byte key)
3=null (0 byte key)
4=blowfish-cbc (5-56 byte key)
5=aes-cbc (16/24/32 byte key)
6=twofish-cbc (16-32 byte key)
encryption algorithm choice : 2
*EncryptionKey (quoted string or raw hex bytes): "123456789012345678901234"
The security association has been created.
This configuration must be saved with the 'ipsec save' command
before it can take effect, or to discard this configuration
use the 'ipsec cancel' command.
See also ipsec, page 160
ipsec list, page 165
ipsec policy, page 168
To Next Page
Loading...
Need help?
General