To Next PageTo Next PageWhy the Disable/ Enable or the Enable/Disable button on the Data Retention window is unavailable on HP XP7 Storage?
If The Disable/ Enable or the Enable/Disable button on the Data Retention window is unavailable on HP Storage, it is because you have been making changes in the Data Retention window, but the changes have not been applied to the storage system. Apply the changes first, then perform the extension lock operation.
Why the number of days in the Retention Term does not decrease on HP XP7?
The number of days in the Retention Term is calculated based on the operating time of the storage system.
What to do if HP XP7 Storage logical devices are not recognized by the host?
If the HP Storage logical devices are not recognized by the host, verify the following: * The READY indicator lights on the disk array are ON. * Fiber cables are correctly installed and firmly connected. * The TIDs/WWNs on each bus are unique. Do not install two devices with the same ID on the same bus. Recheck the buses for new devices. * The maximum number of LUSE devices per port has not been exceeded. * The disk array host mode is set correctly.
What to do if HP Storage host hangs or devices are declared and the host hangs?
If the HP Storage host hangs or devices are declared and the host hangs, ensure that there are no duplicate disk array TIDs and that disk array TIDs do not conflict with any host TIDs.
What to do if HP XP7 Storage host does not reboot properly after hard shutdown?
If the HP Storage host powers off without executing the shutdown process, wait three minutes to allow the disk array's internal timeout process to purge queued commands. If the host restarts while the disk array is processing queued commands, the host may not reboot successfully.
What to do if HP XP7 host detects a parity error?
If the HP Storage host detects a parity error, check the FCA and make sure it was installed properly. Reboot the host.
Traditional host-based volume management methods using physical volumes with fixed capacity.
Function used to create, configure, or delete a customized volume (LDEV).
Advanced software for saving costs and reducing management expenses.
Software to reduce storage costs and increase performance using tiered storage media.
License and software installation requirements for Thin Provisioning and Smart Tiers.
Overview of LUN Manager and its role in managing logical volumes.
Troubleshooting steps for Virtual LUN failures.
Instructions for troubleshooting Thin Provisioning issues.
Actions in Remote Web Console GUI and their corresponding RAID Manager commands.
Window to create, delete, view, edit, or export information about resource groups.
Window to view information about parity groups assigned to the logged-on user.
Window for managing pools, displaying capacity, status, and configuration.
Window to assign access attributes to open-system volumes.
Window for managing ports and host groups.
General
