To replace the component, reverse the removal procedure.
Removing and replacing the chassis retention bracket
CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before beginning
any installation, removal, or replacement procedure. Improper grounding can cause electrostatic discharge.
Prerequisites
Before you perform this procedure, make sure that you have the components included with the hardware kit.
Procedure
1.
Power down the system (Power down the system).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the system.
3. Remove the system from the rack (
Remove the system from the rack).
4. Place the system on a flat, level surface.
5. Remove the chassis retention bracket.
Removal and replacement procedures
119
To Next Page
Loading...
