HPE Apollo 4200 Gen10

To replace the component, reverse the removal procedure.
Removing and replacing a fan
Procedure
1. Power down the system (Power down the system).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
3. Remove the system from the rack (
Remove the system from the rack).
4. Place the system on a flat, level surface.
5. Remove the access panel (Remove the access panel).
6. Remove the fan.
To replace the component, reverse the removal procedure.
Removing and replacing a rear NVMe drive cage air bale
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• The components included with the hardware kit
• Torx T-15 screwdriver
Procedure
1. Power down the system (
Power down the system).
2. Remove all power:
Removal and replacement procedures
61