HPE Apollo 4200 Gen10

To replace the component, reverse the removal procedure.
Removing and replacing an M.2 SSD
Procedure
1. Power down the system (Power down the system).
2. Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the system.
3.
Remove the system from the rack (
Remove the system from the rack).
4.
Place the system on a flat, level surface.
5.
Remove the access panel (
Remove the access panel).
6.
If you are removing an expansion board or controller installed in the PCI riser cage, remove the riser cage.
7.
Disconnect any cables that are connected to the expansion board or controller.
8.
Remove the M.2 enablement board.
• Remove the M.2 enablement board from an onboard expansion slot.
Removal and replacement procedures
52