a. Determine the status of the drive from the NVMe LEDs (NVMe drive components and LEDs).
b. Press the power button.
The Do Not Remove button illuminates and flashes.
c. When the Do Not Remove button stops flashing and the icon on the button is no longer illuminated, press the Do
Not Remove button to release the release lever.
d. Pull the release lever to disengage the drive from the backplane, and slide the drive out of the drive bay.
• Remove a uFF drive
a.
Observe the LED status of the drive and determine if it can be removed (SFF flash adapter components and LED
definitions).
b.
Remove the drive.
To remove the drive carrier:
Removal and replacement procedures
51
To Next Page
Loading...
