HPE Apollo 4200 Gen10

Specifications
Environmental specifications
Specification Value
Temperature range
1
—
Operating
10°C to 35°C (50°F to 95°F)
Nonoperating
-30°C to 60°C (-22°F to 140°F)
Relative humidity (noncondensing)
—
Operating
8% to 90%. 28°C (824°F), maximum wet bulb temperature
Nonoperating
5% to 95%
387°C (1017°F), maximum wet bulb temperature
1
All temperature ratings shown are for sea level. An altitude derating of 10°C per 305 m (18°F per 1000 ft) to 3050 m (10000 ft) is
applicable. No direct sunlight allowed. Maximum rate of change is 20°C per hour (36°F per hour). The upper limit and rate of change might
be limited by the type and number of options installed.
For certain approved hardware configurations, the supported system inlet temperature range is extended:
• 5°C to 10°C (41°F to 50°F) and 35°C to 40°C (95°F to 104°F) at sea level with an altitude derating of 10°C per every 175
m (18°F per every 574 ft) above 900 m (2953 ft) to a maximum of 3050 m (10000 ft).
• 40°C to 45°C (104°F to 113°F) at sea level with an altitude derating of 10°C per every 125 m (18°F per every 410 ft)
above 900 m (2953 ft) to a maximum of 3050 m (10000 ft).
The approved hardware configurations for this system are listed on the Hewlett Packard Enterprise website (http://
www.hpe.com/servers/ASHRAE).
Mechanical specifications
Specification
Value
Height 8750 mm (344 in)
Depth 82550 mm (3250 in)
Width 4480 mm (1763 in)
Weight (approximate values) —
24-bay LFF drive models —
Without the four-bay rear LFF drive cage option, minimum 2234 kg (4925 lb)
Without the four-bay rear LFF drive cage option, maximum
3974 kg (8763 lb)
Table Continued
Specifications 177