43
Condition: This symptom might occur if the UDP port number of the packets is an odd number
before byte order reversing.
201508030336
Symptom: The router reboots unexpectedly if the IPsec tunnels on the router have been
forwarding traffic for a long period of time.
Condition: This symptom might occur if the IPsec tunnels on the router have been forwarding
traffic for a long period of time.
201507270023
Symptom: The router chooses a dynamic address pool over a static address pool when the
router processes DHCP INFORM packets sent by a client that uses an IP address in the static
address pool.
Condition: This symptom might occur if the dynamic address pool contains all IP addresses of
the static address pool.
201508120238
Symptom: When the router acts as a DHCP server, DHCP clients obtain IP addresses after a
long delay.
Condition: This symptom might occur if the DHCP clients have errors and are moved from
another network.
201508030441
Symptom: Routes configured by using the ppp ip-pool route command are lost after an IRF
master/subordinate switchover.
Condition: This symptom might occur if an IRF master/subordinate switchover occurs.
201507160240
Symptom: IMC cannot display the rules of ACLs.
Condition: None.
201508130129
Symptom: The router does not prompt for LDP session reset after the LSR ID is modified, and
then MPLS has status or forwarding errors.
Condition: This symptom might occur if the mpls lsr-id command is used to modify the LSR ID.
201508110265
Symptom: The FTP user is logged off after FTP finishes transferring files to the storage medium
of the standby MPU.
Condition: This symptom might occur if FTP is used to transfer large files to the storage medium
of the standby MPU.
201508110026
Symptom: The router reboots unexpectedly if the IPsec over L2TP tunnels on the router have
been forwarding traffic for a long period of time.
Condition: This symptom might occur if the IPsec over L2TP tunnels on the router have been
forwarding traffic for a long period of time.
201504210203
Symptom: A centralized IRF member router halts during reboot after its operating mode is
changed from IRF to standalone.
Condition: This symptom might occur if the following operations have been performed on the
router:
To Next Page
Loading...
