For the best possible BladeSystem and Virtual Connect experience, and to prevent a future reboot,
Hewlett Packard Enterprise requires updating the Onboard Administrator and Virtual Connect to the
correct version before installing an HPE ProLiant Gen10 server blade. The version information is on the
tag on the front of the server blade.
For more information on this and other specific firmware and driver requirements, as well as the latest
firmware and driver versions, download the latest SPP from the Hewlett Packard Enterprise website
(http://www.hpe.com/servers/spp/download).
Procedure
1. Remove the device bay blank.
Retain the blank for future use.
2. Remove the enclosure connector cover.
Retain the cover for future use.
3. Install the server blade.
Setup 43
To Next Page
Loading...
