HPE ProLiant BL460c Gen10

Remove the direct connect SATA cable
Prerequisites
To remove the direct connect SATA cable, you need a T-15 Torx screwdriver.
Procedure
1. Power down the server blade on page 21.
2. Remove the server blade on page 22.
3. Place the server blade on a flat, level work surface.
4. Remove the access panel on page 22.
5. Remove the direct connect SATA cable.
1
2
3
4
5
Install the direct connect SATA cable
Prerequisites
To install the direct connect SATA cable, you need a T-15 Torx screwdriver.
Procedure
1. Power down the server blade on page 21.
2. Remove the server blade on page 22.
3. Place the server blade on a flat, level work surface.
4. Remove the access panel on page 22.
5. Install the direct connect SATA cable.
Operations 31