HPE ProLiant DL160 Gen10 - Results; Removing and replacing an M.2 SSD; Prerequisites; Procedure

ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing an M.2 SSDRemoving and replacing an M.2 SSD
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
ProcedureProcedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
7. Remove the access panel.
8. Remove the primary PCI riser cage.
9. Remove the M.2 SSD enablement board .
10. Remove the M.2 SSD.
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 76