HPE ProLiant DL160 Gen10 - Removing and replacing the 8 SFF drive backplane; About this task

9. To install the new 4 LFF drive backplane:
a. Position the backplane on the drive cage using the spools on the base of the chassis for alignment (callout 1).
b. To make sure the backplane is fully seated in the drive cage, carefully press down on the backplane (callout 2).
10. Perform the rest of the post-installation steps.
Removing and replacing the 8 SFF drive backplaneRemoving and replacing the 8 SFF drive backplane
About this taskAbout this task
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 60