HPE ProLiant DL160 Gen10 - Removing the primary PCI riser blank; Prerequisites; Procedure

Removing the primary PCI riser blankRemoving the primary PCI riser blank
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
ProcedureProcedure
1. Back up all server data.
2. If installed, remove the bezel.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
Extend the server from the rack. .
Remove the server from the rack .
6. Remove the access panel.
7. Remove the primary PCI riser blank:
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 40