HPE ProLiant DL160 Gen10 - Results; Removing and replacing the quick-release bezel ears; Prerequisites; Procedure

ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the Removing and replacing the quick-release bezel earsquick-release bezel ears
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
ProcedureProcedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove the server from the rack .
4. Remove all rails.
a. Extend the left outer rail from the server.
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 48