This symbol indicates the presence of moving parts inside the product that may present a pinch point if improperly contacted.
WARNING:WARNING:
Hazardous moving parts. Do not insert any tools or any part of your body into the product while it is operating or in
any openings.
Rack warnings and cautionsRack warnings and cautions
WARNING:WARNING:
When all components are removed, the server weighs 10.00 kg (22.03 lb). When all components are installed, the server can
weigh up to 16.00 kg (35.27 lb).
Before configuring your rack solution, be sure to check the rack manufacturer weight limits and specifications. Failure to do
so can result in physical injury or damage to the equipment and the facility.
WARNING:WARNING:
The server is heavy. To reduce the risk of personal injury or damage to the equipment, do the following:
Observe local occupational health and safety requirements and guidelines for manual material handling.
Get help to lift and stabilize the product during installation or removal, especially when the product is not fastened to
the rails. The server weighs more than 10.00 kg (22.03 lb), so at least two people must lift the server into the
together. An additional person may be required to help align the server if the server is installed higher than chest level.
Use caution when installing the server in or removing the server from the .
Adequately stabilized the before extending a component outside the . Extend only one component at a time. A may
become unstable if more than one component is extended.
Do not stack anything on top of rail-mounted component or use it as a work surface when extended from the rack.
WARNING:WARNING:
To reduce the risk of personal injury or damage to the equipment, be sure that:
The rack has anti-tip measures in place. Such measures include floor-bolting, anti-tip feet, ballast, or a combination as
specified by the rack manufacturer and applicable codes.
The leveling jacks (feet) are extended to the floor.
The full weight of the rack rests on the leveling jacks (feet).
The stabilizing feet are attached to the rack if it is a single-rack installation.
The racks are coupled together in multiple rack installations.
WARNING:WARNING:
To reduce the risk of personal injury or equipment damage when unloading a rack:
At least two people are needed to safely unload the rack from the pallet. An empty 42U rack can weigh as much as 115
kg (253 lb), can stand more than 2.1 m (7 ft) tall, and might become unstable when being moved on its casters.
Never stand in front of the rack when it is rolling down the ramp from the pallet. Always handle the rack from both
sides.
To Next Page
Loading...
