ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the energy pack and holderRemoving and replacing the energy pack and holder
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel.
6. Disconnect the cable and then remove the energy pack.
To Next Page
Loading...
