HPE ProLiant DL160 Gen10 - Results; Removing and replacing the SFF front I;O assembly; Prerequisites; About this task

ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the SFF front I/O assemblyRemoving and replacing the SFF front I/O assembly
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Do one of the following:
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 81