T-10 Torx screwdriver
T-15 Torx screwdriver
T-30 Torx screwdriver
System board handle tool
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Install the system board assembly:
a. Install the system board handle tool on top-right corner of bolster of processor 1.
b. Hold the handle tool to insert the ports into the rear panel, and then install the system board assembly on the chassis.
c. Install the screws on the system board.
To Next Page
Loading...
