Removing and replacing a DIMMRemoving and replacing a DIMM
PrerequisitesPrerequisites
Before replacing memory, read the memory configuration and population guidelines in the server user guide.
ProcedureProcedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel.
6. Remove the DIMM.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the DIMM guardsRemoving and replacing the DIMM guards
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
To Next Page
Loading...
